OTP taktikalised püksid VERSASTRETCH
- Channels on the legs bottom for ribbon or cord
- YKK® zippered fly
- Two zippered mesh pockets with reversed YKK® zipper
- Elastic webbing inside cargo pockets for spare magazines, small individual equipment, small bandage or other essentials
- Two classic front pockets with hook&loop flaps, for smartphone or AR/AK magazine
- Classic "jeans" neck preventing pants from riding down
- Profiled back of the leg - divided and joined under the knee
- Knee reinforcements with place for soft pads
- Elastic belt with hook&loop adjustment
- Two loops for d-ring or carabiner
- Two mesh pockets with edges reinforced for knife/flashlight clip
- Wide mesh back pockets, can be used as dump pouch
- Two narrow pockets inside the back pockets for magazines or baton (with possibility of depth expanding)
Many of our customers operate not only in cities, but in the boondocks as well. Listening to their positive feedback about using UTP®, our designers have created their special outdoor version & voila, that's Outdoor Tactical Pants®. They have retained all functionalities of their predecessor, but some details were tweaked to better fit the terrain use. The fabric used is light, elastic and superbly breathable. Lends itself superbly for outdoor activities. Protects from light rain and winter. Dries quickly. The cut and pocket layout retain the civilian outlook, not disclosing the operator. The OTP® design allows to carry all essential equipment, and anatomic cut does not hinder movements. Elastic waistband and velcro-closure allow a degree of adjustability within size. Large belt loops allow wide belts to be used (EDC, UTL® or Cobra®, up to 50 mm width). The jeans cut on the rear part of the pants prevents them from sliding down. Pocket layout allows to distribute the load close to the center mass & around hips and waist. Pocket edges are reinforced to withstand constant sliding of the light and knives clips. Two Velcro-closed front pockets are big enough to take a smart phone or a spare rifle (AK/AR) magazine. Zippered thigh pockets seem small enough, but they would carry a wallet or a small pouch. Internal knee pockets allow to use our Neoprene Low Profile Protection Pads. A wide variety of colors allow to find the proper one to match the working conditions or other garments.
SIZE & FIT CHARTS
We would like to ensure that the apparel you purchase really fits you – in order for them to perform their purpose properly. Please invest a moment of your valuable time to check out the measurements guide and corresponding size table to avoid errors.
To take the right measure, please find the clothes that fit you well and measure it.
Button up the clothes and lay it on a flat surface. Measure from left edge to right edge just below the sleeves.
Button up the clothes and lay it on a flat surface. Measure from left edge to right edge at the waistline.
Wearing a shirt that you like, measure with an arm at your side, from the shoulder's seam all along the arm until you find the desired length. We recommend that the sleeve should go to the base of your thumb (located at the wrist joint).
In the jackets with raglan sleeves, like Stratus® or Cumulus®, the sleeve measurements should be taken from the base of the collar down to the sleeve cuff.
Button up the pants. Lay the pants out on a flat surface. Measure the inseam distance from crotch, where the front and back seams meet, to the bottom of the leg.
Button up the pants. Lay the pants out on a flat surface with outseams at both edges. Take care to pull any wrinkles and fullness from the back panel. Measure the distance from the top of the waistband to the bottom of the hem.
Lay down flat the skirt that best matches your size with the side stitching facing upwards. Use your hand to flatten/straighten any wrinkles on the fabric. Next measure the distance between the top edge point and the bottom edge point. To have the most accurate result you should measure this along the side stitching.
Lay down flat the skirt that best matches your size with the front zipper facing upwards. Use your hand to flatten/straighten any wrinkles on the fabric. Measure the top part of the skirt (the waist line) starting from one sides edge point to the opposite side edge point. Next, double the result to get the waist circumference.
Lay down flat the skirt that best matches your size with the front zipper facing upwards. Use your hand to flatten/straighten any wrinkles on the fabric. Next measure the distance between the opposite side points on the hip part (depending on the skirt cut, the hips should be about 11-14cm below the top edge of the skirt). Double the result to get the hips circumference.
TOLERANCE FOR THE DIMENSIONS GIVEN IN THE TABLE IS +/- 2 CM (APPLIES ONLY TO CLOTHING).
|1/2 leg circumference at the bottom||20||21||21,5||22||22,5||23||23|
short / regular / long / x-long
|103 / 108,5 / 114 / 119||103,5 / 109 / 114,5 / 119,5||104 / 109,5 / 115 / 120||104 ,5 / 110 / 115,5 / 120,5||105 / 110,5 / 116 / 121||105,5 / 111 / 116,5 / 121,5||106 / 111,5 / 117 / 122|
short / regular / long / x-long
|76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5||76,5 / 81,3 / 86,4 / 91,5|
Outdoor tactical shorts 11'' Versastretch Lite
Very light, with cargo pockets
Outdoor tactical Ultra shorts - Versastretch Lite
Covert tactical pants VERSASTRETCH Lite
Mechanix The Original